-
1 Belastungsfaktor des Impulsübertragers
коэффициент нагрузки импульсного трансформатора
Отношение приведенного сопротивления нагрузки к сумме приведенного сопротивления нагрузки и внутреннего сопротивления генератора по эквивалентной схеме импульсного трансформатора
[ ГОСТ 20938-75]Тематики
Классификация
>>>Синонимы
EN
DE
FR
- facteur de charge du transformateur d’impulsion
90. Коэффициент нагрузки импульсного трансформатора
Коэффициент нагрузки
D. Belastungsfaktor des Impulsübertragers
E. Load factor
F. Facteur de charge du transformateur d’impulsion
Отношение приведенного сопротивления нагрузки к сумме приведенного сопротивления нагрузки и внутреннего сопротивления генератора по эквивалентной схеме импульсного трансформатора
Источник: ГОСТ 20938-75: Трансформаторы малой мощности. Термины и определения оригинал документа
Немецко-русский словарь нормативно-технической терминологии > Belastungsfaktor des Impulsübertragers
-
2 Bemessungsfaktor für zyklische Last
коэффициент циклической токовой нагрузки (кабелей)
Коэффициент, на который может быть умножен номинальный ток установившегося режима, соответствующий коэффициенту нагрузки 100 %, для получения допустимого пикового значения тока в течение суточного цикла, при котором температура токопроводящей жилы в течение этого цикла достигает, но не превышает максимально допустимое значение
[IEV number 461-23-02]EN
cyclic rating factor
factor by which the permissible steady-state rated current corresponding to a 100 % load factor may be multiplied to obtain the permissible peak value of current during a daily cycle such that the conductor attains, but does not exceed, the maximum rated temperature during the cycle
[IEV number 461-23-02]FR
facteur de régime cyclique
facteur par lequel le courant assigné admissible en régime permanent, correspondant à un facteur de charge 100 %, peut être multiplié pour obtenir la valeur de pointe du courant au cours d'un cycle journalier, de sorte qu'au cours de ce cycle, l'âme atteigne sans la dépasser la température assignée maximale
[IEV number 461-23-02]Тематики
- кабели, провода...
EN
DE
FR
Немецко-русский словарь нормативно-технической терминологии > Bemessungsfaktor für zyklische Last
-
3 Spannungsänderung bei einer bestimmten Belastung
падение или повышение напряжения при заданном режиме нагрузки
Разность между напряжением холостого хода обмотки и напряжением на ее выводах при заданных нагрузке и коэффициенте мощности при условии, что к другой (или к одной из других) обмотке(ок) подведено напряжение, равное:
- номинальному, если трансформатор включен на основное ответвление (в этом случае напряжение холостого хода рассматриваемой обмотки равно номинальному);
- напряжению другого ответвления, на которое включен трансформатор. Падение или повышение напряжения обычно выражают в процентах напряжения холостого хода рассматриваемой обмотки.
Примечание — В многообмоточном трансформаторе падение или повышение напряжения зависит от нагрузки и коэффициента мощности не только данной обмотки, но и других обмоток
(МЭС 421-07-03).
[ ГОСТ 30830-2002]EN
voltage drop or rise for a specified load condition
voltage regulation for a specified load condition
the arithmetic difference between the no-load voltage of a winding and the voltage developed at the terminals of the same winding at a specified load and power factor, the voltage supplied to (one of) the other winding(s) being equal to:
- its rated value if the transformer is connected on the principal tapping (the no-load voltage of the former winding is then equal to its rated value);
- the tapping voltage if the transformer is connected on another tapping.
This difference is generally expressed as a percentage of the no-load voltage of the former winding
NOTE – For multi-winding transformers, the voltage drop or rise depends not only on the load and power factor of the winding itself, but also on the load and power factor of the other windings
[IEV number 421-07-03]FR
hute ou augmentation de tension pour une condition de charge spécifiée
différence arithmétique entre la tension à vide d'un enroulement et la tension en charge aux bornes du même enroulement pour un courant de charge et un facteur de puissance spécifiés, la tension appliquée à l'autre (ou à l'un des autres) enroulement(s) étant égale:
- à sa valeur assignée, si le transformateur est connecté sur la prise principale (la tension à vide du premier enroulement étant alors égale à sa valeur assignée);
- à la tension de prise si le transformateur est connecté sur une autre prise.
Cette différence s'exprime généralement sous la forme d'un pourcentage de la tension à vide du premier enroulement
NOTE – Pour les transformateurs à plus de deux enroulements, la chute ou l'augmentation de tension dépend non seulement de la charge et du facteur de puissance de l'enroulement lui-même, mais aussi de la charge et du facteur de puissance des autres enroulements.
[IEV number 421-07-03]Тематики
Классификация
>>>EN
- voltage drop or rise for a specified load condition
- voltage regulation for a specified load condition
DE
FR
Немецко-русский словарь нормативно-технической терминологии > Spannungsänderung bei einer bestimmten Belastung
-
4 Anzapfungsfaktor
коэффициент ответвления (соответствующий конкретному ответвлению)
Отношение Uотв/Uном (коэффициент ответвления) либо 100 Uотв/Uном ((коэффициент ответвления, выраженный в процентах), где
Uном — номинальное напряжение обмотки, В (см. 3.4.3), a
Uотв — напряжение, возникающее при холостом ходе между выводами обмотки, присоединенной к данному ответвлению, при приложении номинального напряжения к обмотке без ответвлений, В.
Примечание — Это определение не распространяется на последовательную обмотку линейного регулировочного трансформатора (см. 3.1.3), для которого коэффициент ответвления, выраженный в процентах, относится к напряжению обмотки возбуждения или обмотки сетевого трансформатора, связанного с линейным регулировочным трансформатором
(МЭС 421-05-03).
[ ГОСТ 30830-2002]EN
tapping factor
the ratio Ud/ UN (tapping factor) or 100 Ud/ UN (tapping factor expressed as a percentage)
where:
UN is the rated voltage of the winding
Ud is the voltage which would be developed at no-load at the terminals of the winding, connected on the tapping concerned, by applying rated voltage to an untapped winding
NOTE – The tapping factor expresses the relative value of the "effective number of turns" of the tapped winding at the relevant tapping, the basis 1 being the effective number of turns of this winding at the principal tapping
[IEV number 421-05-03]FR
facteur de prise
rapport Ud/ UN (facteur de prise) ou 100 Ud/ UN (facteur de prise exprimé sous la forme d'un pourcentage)
où:
UN est la tension assignée de l'enroulement,
Ud est la tension qui serait développée aux bornes de l'enroulement, connecté sur la prise considérée, en fonctionnement à vide, en appliquant à un enroulement sans prise sa tension assignée
NOTE – Le facteur de prise exprime la valeur relative du "nombre effectif de spires" de l'enroulement à prises pour la prise considérée, la base 1 étant le nombre effectif de spires de cet enroulement pour la prise principale.
[IEV number 421-05-03]Тематики
Классификация
>>>EN
DE
FR
Немецко-русский словарь нормативно-технической терминологии > Anzapfungsfaktor
См. также в других словарях:
Load factor — may refer to:* Capacity factor, the ratio of the actual output of a power plant over a period of time and its output if it had operated a full capacity of that time period * Load factor (aerodynamics), n, is the vector expressed by the ratio of… … Wikipedia
load factor — ➔ factor1 * * * load factor UK US noun [S] ► TRANSPORT the number of paying passengers in relation to the number of seats available on a plane during a particular period: »The increased profitability for the last quarter reflects a rise in the… … Financial and business terms
load factor — n. Elec. the ratio of average load to greatest load … English World dictionary
load factor — i. The ratio of a specified load to the total weight of the aircraft. The specified load is expressed in terms of aerodynamic forces or ground or water reaction. Aerodynamically, it is the ratio of the total lift to the weight. The load factor is … Aviation dictionary
Load Factor — The ratio of average energy demand (load) to maximum demand (peak load) during a specific period. The ratio of the average load supplied to the peak or maximum load during a designated period. Load factor, in percent, also may be derived by… … Energy terms
load factor — 1. the amount or weight of cargo, number of passengers, etc., that an aircraft, vehicle, or vessel can carry. 2. the percentage of available seats, space, or maximum carrying weight paid for and used by passengers, shippers, etc.: An airline can… … Universalium
load factor — apkrautumo faktorius statusas T sritis radioelektronika atitikmenys: angl. capacity factor; load factor; loading factor vok. Belastungsfaktor, m; Belastungsverhältnis, n; Lastfaktor, m rus. коэффициент нагрузки, m pranc. facteur de charge, m … Radioelektronikos terminų žodynas
load factor — apkrovos koeficientas statusas T sritis automatika atitikmenys: angl. load factor vok. Belastungsfaktor, m; Belastungsgrad, m; Lastfaktor, m rus. коэффициент нагрузки, m pranc. facteur de charge, m … Automatikos terminų žodynas
load factor — apkrovos faktorius statusas T sritis fizika atitikmenys: angl. load factor vok. Arbeitsausnutzung, f rus. фактор нагрузки, m pranc. facteur de charge, m … Fizikos terminų žodynas
Load factor (aerodynamics) — Load factor is the ratio of the lift on an aircraft to the weight of the aircraft.Clancy, L.J., Aerodynamics , section 5.22] Hurt, H.H., Aerodynamics for Naval Aviators , page 37] The load factor is expressed in multiples of g where one g… … Wikipedia
load factor — load′ fac tor n. cvb the percentage of available seats, space, or carrying weight paid for and used by passengers, shippers, etc • Etymology: 1890–95 … From formal English to slang